Molding Process – Hot Pressing
Brake pad hot press molding is a technique that bonds friction materials to a steel backing through high temperature and pressure, primarily used in brake pad manufacturing. The mixture is poured into a mold and formed under high-temperature pressure to create a preliminary brake pad shape.
- Compression Molding: A high-pressure press compresses a hot-formed blank to create a support plate with anti-slip textures.
- Weaving Process: Non-asbestos fibers are mixed with resin, woven, and then thermally cured via hot pressing.
I. Principles of Hot Press Molding
Process Flow
Place the friction material and adhesive-coated steel backing into the hot press mold. High temperature and pressure bond the two. The process requires precise control of temperature, pressure, and time.
Hot pressing methods include:
- Positive Mold Pressing: Material is pressed into the mold.
- Plate Mold Pressing: Material is fixed within the mold.
Material Properties
Friction materials (e.g., phenolic resin thermoplastics) require hot pressing to fully cure the resin, eliminate thermal stress, reduce thermal expansion, and enhance thermal friction performance.
II. Equipment Structure and Operation
Equipment Components
- Heating plates (single/double-sided heating)
- Hydraulic cylinders
- Cooling systems (water/air-cooled)
- Ejection mechanisms to ensure uniform heating and rapid demolding.
Time Optimization
Dwell time significantly impacts friction coefficient stability. Extending heat treatment time compensates for performance loss caused by shortened pressing time.

Operational Workflow
1. Power on the equipment, input process parameters, and initiate heating.
2. Install the mold corresponding to the product model. Clean mold surfaces of dust and impurities.
3. Retrieve materials per the *Process Manual* for the product type. Weigh materials using designated cups.
4. Once the mold reaches the target temperature, press *Motor Start*. Rotate the *Up/Down* knob to lower the mold to its lowest position. Apply release agent to upper/lower molds and cavities.
5. Rotate the *Ejector Retract/Extend* knob to eject the middle mold.
6. Pour material into the cavity, spread evenly, clean excess with a brush, and place the steel backing flush with the mold. Press *Auto Start* to begin pressing.
7. After demolding, inspect edge clearance, trim flash, measure product thickness, and verify surface quality against drawings. Arrange finished products neatly on trays.
8. Before the next cycle, clean residual material from the mold core with a scraper and reapply release agent to the middle mold surface. Repeat Step 5.
Maintenance
Electrical Components
- Daily: Clean dust; check button and wire connections.
- Monthly: Inspect all buttons.
- Biannually: Tighten wiring connections (spring/autumn).
Mechanical Components
- Monthly: Lubricate bearings.
- Annually: Disassemble and clean bearings.
Pressure Gauges: Inspect every 6 months.
Oil Tank & Hydraulic Oil: Clean the tank and replace oil annually.
Post-Processing
After molding, surface treatment and performance testing ensure brake pads meet wear resistance and friction coefficient requirements.
Precise control of hot press parameters enhances brake pad performance, production efficiency, and cost-effectiveness.






